257
11
Chapter 14 System Environment Settings
14
Display Color Screen background and character colors on the Waveform screen can be set as
desired. Select [Color Edit] change the [R] (red), [G] (green) and [B] (blue) values
of each item to change its color.
( p.258)
Beep Sound This function audibly indicates warnings and operating conditions by beep
sounds.
Language Selects the display language.
Auto Scale Variable values are automatically changed according to changes in scaling and
voltage range.
See: "8.6 Variable Function (Setting the Waveform Display Freely)" ( p.134)
Start Action To prevent operating mistakes from unintentionally starting measurement, the
START key operation method can be changed. This setting does not affect
external control terminal functions.
* When the START key is pressed, "Hold START key down." appears. After
pressing for two seconds, the message disappears and measurement starts.
Stop Action Normally, pressing the STOP key once causes measurement to stop after the
specified recording length is completed, and pressing it twice stops measure-
ment immediately. However, this setting is provided to allow a single press to
stop measurement.
Color 1 / Color 2 / Color 3 / Color Edit
Off Beep sounds are disabled.
Warning
Beeps sound for error messages (warning displays) and upon NG (fail) judg-
ments. (default setting)
Warn+Act
In addition to the warning beeps above, beeps sound to indicate start, trigger,
stop and auto-save-finish.
English (default setting)/ Japanese / Korean/ Chinese
Off / On (default setting)
One Push Measurement starts by pressing once. (default setting)
Two Push
Measurement starts by pressing twice.
Hold 2s*
Measurement starts by pressing for two seconds.
Two Push Press the key twice to stop measurement. (default setting)
One Push
Press the key once to stop measurement.
To Next Page
Loading...