2.3 Recording Media Preparation
29
2
Chapter 2 Measurement Preparations
Depending on the intended use of the USB memory stick, connector types and
settings at the instrument will differ, as listed in the table below.
Storage
Media
Inserting procedure, Remarks, and Notes
CF Card
HDD
(Hard disk)
9664 HD Unit (capacity: 80 GB 1GB=1,000,000,000 bytes)
The optional 9664 HD Unit (factory option) is required.
The hard disk is formatted at the factory.
RAM
(Internal
memory)
• Memory integrated in the unit is used. Only settings can be stored.
• Automatic saving of data is not possible.
USB
memory
stick
Inserting a CF Card
With the Front mark () pointing toward the slot, insert the card
in the direction of the arrow all the way in.
When the Eject button has popped out, press it down first before
inserting the CF card all the way in. Inserting the CF card when
the Eject button is not pressed down may cause damage to the in-
strument. If the CF card cannot go all the way in, do not force it in.
Press the Eject button to pop it out, and then press it down again
before inserting in the CF card all the way in.
Removing a CF Card
Press the Eject button. When the button pops out, press it again
to eject the CF Card.
CF Card Slot
Inserting a USB memory stick
Ensure correct orientation of the USB memory stick and push it all the way
into the connector.
Remove a USB memory stick
Verify that the unit is not accessing the USB memory stick (for saving or load-
ing data, etc.). Then pull the USB memory stick out. (No special steps are
required at the instrument.)
USB Connector (Type A)
• Do not connect any devices other than USB memory stick.
• Not all commonly available USB memory sticks are supported.
• Automatic saving of data is not possible.
• To use a USB memory stick, suitable unit settings must be made, as
described below.
USB use
Connec-
tor
8847 setting
Reference information
Interface USB setting
As USB memory stick Type A LAN USB Stick Reference procedure
For transfer of files from hard disk of PC
(using a USB cable)
Type B LAN Mass Storage "15.4"( p.276)
For communication with PC (using a USB cable) Type B USB Interface "15.6.1"( p.278)
Procedure
To open the screen: Press the SYSTEM key → [Interface] sheet
1
Move the cursor to the [Interface], and select [LAN].
2
Move the cursor to the [USB Set], and select [USB Stick].
To Next Page
Loading...