5.3 Loading Data
78
When the following index files are loaded, waveform data can be loaded as a batch. With the following
settings, index files are created along with waveform files.
When loading from a source other than the built-in HDD
Insert the storage media before making the media selection.
Other limitations
• Data saved with a Memory HiCorder model other than the 8847 cannot be
loaded into the 8847.
• When loading waveform data, the settings for the instrument are the same set-
tings as when the data is saved. To reset to the instrument settings, carry out
[Clear Wave Data] ( p.314) or start the measurement.
Batch load of waveform data
Extension Explanation
IDX
Divided files are loaded together.
(To create index files: Use [Division] at the [File Save] sheet of the System screen to set the dividing
size and then save. Note: If [Save type] is not [Wave Binary], index files are not created)
See: "5.2.2 Automatically Saving Waveforms" (
p.69)
"5.2.3 Saving Data Selectively (SAVE Key)" (
p.74)
SEQ
(When using the memory division function of the memory function)
Waveform data of all blocks is loaded together.
(To create index files: At the [Memory Div] sheet of the Status Screen, set [Memory Div] to [On].
At the [File Save] sheet of the System Screen, set [Save Type] to [ALL-Wave Bin].)
See: "12.1 Recording Settings" (
p.203)
"5.2.3 Saving Data Selectively (SAVE Key)" (
p.74)
To Next Page
Loading...