Honeywell Gamewell-FCI E3 Series - Repeater (RPT-E3) Connections; 1: Rpt-E3-Fo; 2: Rpt-E3-Utp; 3: Specifications

152 E3 Series Installation/Operation Manual — P/N 9000-0574:I 11/04/10
E3 Series System Connections Repeater (RPT-E3) Connections
3.11 Repeater (RPT-E3) Connections
The Repeater, RPT-E3 is an optional sub-assembly that provides the interface between the ILI-MB-
E3, ILI95-MB-E3, ANX and the Broadband Network. It can also be used with the NGA. The
RPT-E3 is available in two versions:
• RPT-E3-FO
• RPT-E3-UTP
3.11.1 RPT-E3-FO
The RPT-E3-FO communicates to the network by means of fiber-optic cable or copper, unshielded,
twisted-pair wire.
3.11.2 RPT-E3-UTP
The RPT-E3-UTP connects to the network by means of unshielded, twisted-pair copper wire. It is
similar to the RPT-E3-FO with the exception that connectors U4, U5, U6 and U7 are omitted.
3.11.3 Specifications
The following list the electrical specifications for the RPT-E3.
Operating Voltage: 24 VDC FWR (from PM-9/PM-9G power supply)
Operating Current: 0.013 amp
Operating Temperature: 32° to 120°F (0° to 49°C)
Relative Humidity: 0 to 93%, non-condensing at 90°F (32°C)
Supervised
Power-Limited