prog.book : chapter1.fm 83 Mon Feb 15 09:24:37 1999
Power Meter Remote Operation
Status Reporting
HP E4418B/E4419B Programming Guide 1-83
Questionable Status Register
The questionable status register provides information about the quality of
the power meter’s measurement results. Any or all of these conditions can
be reported in the questionable data summary bit through the enable
register. You must write a value using the
STATus:QUEStionable:ENABle command to set the enable register
mask.
The questionable status model is shown in the pullout at the end of this
chapter.
The following bits in these registers are used by the power meter.
Bit
Number
Decimal
Weight
Definition
0 to 2 - Not used
3 8 POWer Summary
4 to 7 - Not used
8 256 CALibration Summary
9 512 Power On Self Test
10 to 14 - Not Used
15 - Not used (always 0)
To Next Page
Loading...
Need help?
General
