HP E4418B - Page 362

prog.book : ch10stat.fm 3 Mon Feb 15 09:24:37 1999
STATus Subsystem
STATus Subsystem
HP E4418B/E4419B Programming Guide 10-3
As the status reporting commands are orthogonal, the same commands
apply to all the registers. The registers are:
STATus:DEVice (page 10-8)
STATus:OPERation (page 10-11)
STATus:OPERation:CALibrating[:SUMMary] (page 10-12)
STATus:OPERation:LLFail[:SUMMary] (page 10-13)
STATus:OPERation:MEASuring[:SUMMary] (page 10-14)
STATus:OPERation:SENSe[:SUMMary] (page 10-15)
STATus:OPERation:TRIGger[:SUMMary] (page 10-16)
STATus:OPERation:ULFail[:SUMMary] (page 10-17)
STATus:QUEStionable (page 10-20)
STATus:QUEStionable:CALibration[:SUMMary] (page 10-21)
STATus:QUEStionable:POWer[:SUMMary] (page 10-22)
The following five commands operate on each of these registers. However,
to avoid duplication they are only listed once.
For example, to use the :CONDition?command on the STATus:DEVice
register, use:
STATus:DEVice:CONDition?
To use the :NTRansition command on the
STATus:OPERation:SENSe[:SUMMary] register, use:
STATus:OPERation:SENSe[:SUMMary]:NTRansition
Keyword Parameter Form Notes Page
:CONDition? [query only] page 10-4
:ENABle <NRf>|<non-decimal numeric> page 10-5
[:EVENt?] [query only] page 10-4
:NTRansition <NRf>|<non-decimal numeric> page 10-6
:PTRansition <NRf>|<non-decimal numeric> page 10-7