HP E4418B - Page 414

prog.book : ch11syst.fm 31 Mon Feb 15 09:24:37 1999
SYSTem Subsystem
SYSTem:PRESet
HP E4418B/E4419B Programming Guide 11-31
SENS:CORR:LOSS2 0.000 dB External gain
SENS:CORR:LOSS2:STAT OFF External loss correction disabled
SENS:FREQ +50.000 MHz Frequency setting
SENS:LIM:CLE:AUTO ON Clear limit data at INIT
SENS:LIM:FAIL OFF No failures
SENS:LIM:FCO OFF Limit failure count is zero
SENS:LIM:LOW[:DATA] -90.000 dBm Lower limit
SENS:LIM:STAT OFF Limits checking disabled
SENS:LIM:UPP[:DATA] +90.000 dBm Upper limit
SENS:POW:AC:RANG upper Upper range selected
SENS:POW:AC:RANG:AUTO ON Auto-ranging selected
SENS:SPE 20 readings/second Speed
SYST:COMM:SER[:REC]:BAUD not affected Baud rate
SYST:COMM:SER[:REC]:BITs not affected Word length
SYST:COMM:SER[:REC]:PACE not affected Xon/Xoff software handshake
SYST:COMM:SER[:REC]:
PAR[:TYPE]
not affected Parity setting
SYST:COMM:SER[:REC]:SBIT not affected Number of stop bits
SYST:COMM:SER:TRAN:BAUD not affected Baud rate
SYST:COMM:SER:TRAN:BITs not affected Word length
SYST:COMM:SER:TRAN:ECHO not affected Dumb terminal control
SYST:COMM:SER:TRAN:PACE not affected Xon/Xoff software handshake
SYST:COMM:SER:TRAN:
PAR[:TYPE]
not affected Parity setting
SYST:COMM:SER:TRAN:SBIT not affected Number of stop bits
SYST:GPIB:ADDR not affected Power meter address
SYST:ERR not affected Error messages
SYST:LANG not affected Programming language
SYST:VERS not affected SCPI version
TRIG:DEL:AUTO ON Delay after trigger enabled
TRIG:SOUR IMM Trigger source is immediate
UNIT:POW dBm Power units
UNIT:POW:RAT dB Ratio units
Command
Setting Comments