prog.book : chapter1.fm 36 Mon Feb 15 09:24:37 1999
Power Meter Remote Operation
Using Sensor Calibration Tables
1-36 HP E4418B/E4419B Programming Guide
Naming Sensor Calibration Tables
To rename a sensor calibration table use:
MEMory:TABLe:MOVE <string>,<string>
The first <string> parameter identifies the existing table name, and the
second identifies the new table name.
The following rules apply to sensor calibration table names:
a) The sensor calibration table must consist of no more than 12
characters.
b) All characters must be upper or lower case alphabetic characters,
or numeric (0-9), or an underscore (_).
c) No spaces are allowed in the name.
To Next Page
Loading...
