HPE FlexNetwork MSR Series Comware 5 Layer 2 - Wan Access Configuration Guide

108
Configuration procedure
To configure FRF.9 compression:
Step Command Remarks
3. Enter system view.
system-view
N/A
4. Enter frame relay interface or subinterface
view.
interface
interface-type
interface-number
or
interface serial
interface-number.subnumber
N/A
5. Configure
FRF.9
compressio
n (use
either one
according
to interface
type).
For P2P subinterface, enable
FRF.9 compression.
fr compression frf9
Optional.
By default,
FRF.9
compression is
disabled.
For a P2MP interface, enable
FRF.9 compression when
creating static address
mapping.
fr map ip
{ ip-address [ mask ] |
default
} dlci-number [
broadcast
|
[
ietf
|
nonstandard
] ] *
compression frf9
Optional.
Configuring FRF.20 IP header compression
The frame relay function provides IP header compression including RTP/TCP header compression.
You can enable IP header compression on interfaces or when you configure static address mapping.
To configure FRF.20 IP header compression:
Step Command Remarks
6. Enter system view.
system-view
N/A
7. Enter interface view.
interface
interface-type
interface-number
N/A
8. Configure
FRF.20 IP
header
compressio
n.
(Method 1) Enable
FRF.20 IP header
compression on an
interface and provide
FRF.20 IP header
compression option.
fr compression iphc
Optional.
By default,
FRF.20 IP
header
compression is
disabled on
interface.
fr iphc
{
nonstandard
|
rtp-connections
number1 |
tcp-connections
number2 |
tcp-include
}
Optional.
By default,
FRF.20 IP
header
compression
option is not
provided.
(Method 2) Enable
FRF.20 IP header
compression when
creating a static address
mapping.
fr map ip
{ ip-address [ mask ] |
default
} dlci-number [
broadcast
|
[
ietf
|
nonstandard
] ] *
compression iphc connections
number
Optional.
By default, no
static address
mapping is
configured.

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English