HPE FlexNetwork MSR Series Comware 5 Layer 2 - Wan Access Configuration Guide

71
Step Command Remarks
7. Clear ISDN statistics.
isdn statistics clear
Optional.
Configuring an interface to check the calling
number when an incoming call comes
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
N/A
3. Configure the interface to
check the calling number
when an incoming call
comes.
isdn caller-number
caller-number
Execute this command to
configure limited incoming calls.
Configuring progress-to-alerting conversion
When ISDN is processing voice calls, Alerting messages are used as ring indications as defined in
the standard protocol. However, some devices use Progress messages as ring indications. In this
case, convert the received Progress messages into Alerting messages. You can use the related
command to determine whether to perform the conversion. The conversion is needed when the
current device is connected to a device using Progress messages as ring indications. Otherwise, the
conversion is unnecessary. The conversion is enabled by default.
To configure Progress-to-Alerting conversion:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
N/A
3. Configure the ISDN interface
to convert received Progress
messages into Alerting
messages.
isdn message-conversion
progress-to-alerting enable
Optional.
Enabled by default.
Configuring ISDN to carry the Calling-Name field
in outgoing packets
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
N/A

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English