HPE FlexNetwork MSR Series Comware 5 Layer 2 - Wan Access Configuration Guide

62
Step Command Remarks
16. Configure ISDN to carry the
Calling-Name field in
outgoing packets.
See "
Configuring ISDN to carry
the Calling-Name field in
outgoing
packets."
Optional.
17. Configure ISDN to carry the
Connected-Name field in
outgoing packets.
See "
Configuring ISDN to carry
the Connected-Name field in
outgoing pack
ets."
Optional.
18. Configure ISDN to carry the
Channel-ID field for only
once in the response.
See "
Configuring ISDN to carry
the Channel-ID field for only
once
in the responses
."
Optional.
19. Configure the service type in
the ISDN bearer
compatibility signaling.
See "
Configuring the service type
in the ISDN bea
rer compatibility
signaling
."
Optional.
20. Configure the progress
indicator value in the ISDN
signaling.
See "
Setting the progress indicator
va
lue in ISDN signaling
messages."
Optional.
Configuring the negotiation parameters of ISDN
layer 3 protocol
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
N/A
3. Set the length of the call
reference adopted when the
ISDN interface initiates a
call.
isdn crlength
call-reference-length
Optional.
The call reference length is 2
bytes for CE1 PRI and CT1 PRI
interfaces and 1 byte for BRI
interfaces by default.
4. Configure how the ISDN
protocol handles CONNECT
ACK messages.
isdn ignore connect-ack
[
incoming
|
outgoing
]
Optional.
By default, if the router is
communicating with an ISDN
switch:
• The ISDN protocol must wait
for the CONNECT ACK in
response to the CONNECT
message before it can switch
to the ACTIVE state to start
the data and voice service
communications.
• After the ISDN protocol
receives a CONNECT
message, it needs to
respond to the peer with a
CONNECT ACK message.

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English