HPE FlexNetwork MSR Series

27
Task Command Remarks
Display information about an MP
interface.
display ppp mp
[
interface
interface-type
interface-number ] [
|
{
begin
|
exclude
|
include
} regular-expression ]
Available in any view.
Display the statistics on TCP
header compression.
display ppp compression iphc tcp
[ interface-type interface-number ] [
|
{
begin
|
exclude
|
include
}
regular-expression ]
Available in any view.
Display statistics on RTP header
compression.
display ppp compression iphc rtp
[ interface-type interface-number ] [
|
{
begin
|
exclude
|
include
}
regular-expression ]
Available in any view.
Display statistics on Stac LZS
compression.
display ppp compression stac-lzs
[ interface-type interface-number ] [
|
{
begin
|
exclude
|
include
}
regular-expression ]
Available in any view.
Clear all statistics on IP header
compression.
reset ppp compression iphc
[ interface-type interface-number ]
Available in user view.
Clear statistics on Stac LZS
compression.
reset ppp compression stac-lzs
[ interface-type interface-number ]
Available in user view.
Clear statistics on a specified
interface.
reset counters interface
[
mp-group
[ interface-number ] ]
reset counters interface
[
virtual-template
[ interface-number ] ]
Available in user view.
PPP and MP configuration examples
One-way PAP authentication configuration example
Network requirements
As shown in Figure 4, Router A and Router B are interconnected through their Serial 2/0 interfaces.
Configure Router A to authenticate Router B by using PAP, but Router B not to authenticate Router
A.
Figure 4 Network diagram
Configuration procedure
1. Configure Router A:
# Create a user account for Router B.
<RouterA> system-view
[RouterA] local-user userb
# Set a password for the user account.
[RouterA-luser-userb] password simple passb
# Set the service type of the user account to PPP.
[RouterA-luser-userb] service-type ppp