HPE FlexNetwork MSR Series Comware 5 Layer 2 - Wan Access Configuration Guide

26
Figure 3 LFI
To configure LFI:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter VT interface view or
MP-group interface view.
• interface
virtual-template
number
• interface mp-group
mp-number
N/A
3. Enable LFI.
ip tcp vjcompress
By default, LFI is disabled.
4. Set the maximum delay of
transmitting an LFI fragment and
the maximum size (in bytes) of LFI
fragments.
• ppp mp lfi
delay-per-frag time
• ppp mp lfi
size-per-frag size
Use either command.
The default maximum delay of
transmitting an LFI fragment is 10
ms, and the default maximum size
of LFI fragments depends on the
configuration of the
ppp mp lfi
delay-per-frag
command.
Displaying and maintaining PPP and MP
Task Command Remarks
Display information about one or
all existing MP-group interfaces.
display interface mp-group
mp-number
[
brief
] [
|
{
begin
|
exclude
|
include
}
regular-expression ]
display interface
[
mp-group
] [
brief
[
down
] ] [
|
{
begin
|
exclude
|
include
}
regular-expression ]
Available in any view.
Display information about a VA
interface or all the VA interfaces
on a VT interface.
display virtual-access
[ va-number |
dialer
dialer-number |
peer
peer-address |
user
user-name |
vt
vt-number ] * [
|
{
begin
|
exclude
|
include
} regular-expression ]
Available in any view.
Display information about an
existing VT interface.
display interface virtual-template
number
[
brief
] [
|
{
begin
|
exclude
|
include
}
regular-expression ]
display interface
[
virtual-template
]
[
brief
[
down
] ] [
|
{
begin
|
exclude
|
include
} regular-expression ]
Available in any view.
Voice packet
Large packet
Output queue
WFQ
Traffic
classifying
Fragmentation
WFQ

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English