HPE FlexNetwork MSR Series Comware 5 Layer 2 - Wan Access Configuration Guide

327
some cases, some address mappings are used for only outgoing calls, and others are used for only
incoming calls.
To restrict the use of an address mapping:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
N/A
3. Disable initiating calls using
an address mapping.
x25 map
protocol-type
protocol-address
x121-address
x.121-address
no-callout
N/A
4. Disable accepting calls
using an address map.
x25 map
protocol-type
protocol-address
x121-address
x.121-address
no-callin
N/A
Configuring X.25 switching
Configuring the basic X.25 switching functionality
A packet network consists of many interconnecting nodes based on a specific topology. A packet is
sent from source to destination through a large number of nodes, of which each node needs to have
packet switching capability.
Simply speaking, X.25 packet switching means, after receiving a packet from an X.25 port or Annex
G DLCI, a switch will select a certain X.25 port or Annex G DLCI to send the packet according to the
related destination information contained in the packet. Introducing X.25 switching enables the
system to implement the packet switching function at the packet layer. The device can act as a
packet switch.
Figure 126 X.25 switching
To configure the basic X.25 switching functionality:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enable X.25 switching.
x25 switching
Disabled by default.

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English