HPE FlexNetwork MSR Series Comware 5 Layer 2 - Wan Access Configuration Guide

193
• MSR30-11F.
• MSR 900.
• MSR93X(except JG518A, JG518B, JG519A, JH013A, JH012B, JG520A and JG597A) .
ATM configuration task list
Task Remarks
Configuring an ATM interface
Required.
Configuring
an ATM
subinterface
Performing basic configurations for an ATM subinterface
Optional.
Checking PVC status to determine the protocol state of an ATM P2P subinterface
Configuring
PVCs and
the
maximum
number of
PVCs
allowed on
an interface
Configuring PVC parameters
Req
uired.
Setting the CLP bit for ATM cells
Optional.
Assigning a transmission priority to an ATM PVC
Configuring PVC service mapping
Optional.
Configuring the maximum number of PVCs allowed on an ATM interface
Optional.
Configuring an ATM class
Optional.
Configuring VP policing
Optional.
Configuring
applications
carried by
ATM
Configuring Layer 3 VE interfaces
Req
uired.
Configuring IPoA
Required.
Use one of
the
methods.
Configuring IPoEoA
Configuring PPPoA
Configuring PPPoEoA
Configuring an ATM interface
Depending on the actual networking environment and system requirements, you might be required
to modify certain parameters of an ATM interface.
Except the mtu command, which can be configured on a subinterface, the ATM settings in this
section must be modified in ATM main interface view, although they apply to both the main ATM
interface and its subinterfaces.
For more information about ATM interface configuration, see HPE FlexNetwork MSR Router Series
Comware 5 Interface Configuration Guide.

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English