11
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
N/A
3. Configure the
polling interval.
timer hold
seconds
Optional.
The default setting is 10 seconds.
Configuring PPP negotiation
PPP negotiation parameters that can be configured are as follows:
• Negotiation timeout time
• IP address negotiation
• DNS address negotiation
• ACCM negotiation
• ACFC negotiation
• PFC negotiation
Configuring the PPP negotiation timeout time
Negotiation timeout time determines the interval for sending request packets. During PPP
negotiation, if no response is received from the peer during a specific period after the local device
sends a packet, the device sends the packet again. The period is known as negotiation timeout time,
which is in the range of 1 to 10 seconds.
To configure the PPP negotiation timeout time:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
N/A
3. Configure the negotiation
timeout time.
ppp timer negotiate
seconds
Optional.
3 seconds by default.
Configuring IP address negotiation
IP address negotiation can be implemented in the following two modes:
• The router operating as the client—This mode applies when a local interface uses PPP as its
link layer protocol but does not have an IP address, whereas the peer is configured with an IP
address and with an address pool. In this mode, the interface accepts an IP address allocated
by its peer. This mode is used for situations where the router accesses the Internet through an
ISP.
• The router operating as the server—In this mode, you must configure a local IP address pool
in domain view or system view to specify the range of the IP addresses to be allocated, and
then bind the address pool to the interface in interface view.
To configure the local end as the client:
Step Command Remarks
1. Enter system view.
system-view
N/A
To Next Page
Loading...
Need help?
General
