HPE FlexNetwork MSR Series Comware 5 Layer 2 - Wan Access Configuration Guide

201
To configure a Layer 3 VE interface:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Create a Layer 3
VE interface and
enter its view.
interface virtual-ethernet
interface-number
If a specified Layer 3 VE interface does not
exist, use this command to first create one
and then enter its view.
You can create up to 1024 Layer 3 VE
interfaces.
3. Set the interface
description.
description
text
Optional.
By default, the description for a VE interface
is interface name Interface, for example,
Virtual-Ethernet0 Interface.
4. Configure the MAC
address for the
interface.
mac-address
mac-address Optional.
5. Set the intended
bandwidth for the
interface.
bandwidth
bandwidth-value Optional.
6. Restore the default
settings for the
interface.
default
Optional.
7. Shut down the
interface.
shutdown
Optional.
Up by default.
Configuring IPoA
When you configure IPoA, follow these guidelines:
• If you execute the map ip command with the broadcast keyword, which specifies pseudo
broadcast, any broadcast packets received by the port on which the PVC is created will be
duplicated to the PVC. Therefore, to propagate broadcast or multicast packets on an ATM PVC
with a broadcast or multicast protocol enabled, specify the broadcast keyword.
• Configure the map ip default broadcast command on PVCs created on P2P ATM
subinterfaces.
• You can configure PVC mapping in PVC view. For more information, see HPE FlexNetwork
MSR Router Series Comware 5 MPLS Configuration Guide.
To configure IPoA:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter ATM interface view.
interface atm
{ interface-number
| interface-number.subnumber }
N/A
3. Create a PVC, and enter
PVC view.
pvc
{ pvc-name [ vpi/vci ] |
vpi/vci }
N/A

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English