HPE FlexNetwork MSR Series Comware 5 Layer 2 - Wan Access Configuration Guide

48
Step Command Remarks
9. Return to system view.
quit
N/A
10. Set the maximum number of
PPPoE sessions allowed for
a peer MAC address.
pppoe-server max-sessions
remote-mac
number
Optional.
100 by default.
11. Set the maximum number of
PPPoE sessions allowed for
a local MAC address.
pppoe-server max-sessions
local-mac
number
Optional.
100 by default.
12. Set the maximum number of
PPPoE sessions allowed for
a device.
pppoe-server max-sessions
total
number
Optional.
4096 by default.
13. Set the upper threshold for
the PPPoE abnormal offline
event count.
pppoe-server
abnormal-offline-count
threshold
number
Optional.
65535 by default.
If the PPPoE abnormal offline
event count in the last 5 minutes
exceeds this threshold, the
system outputs a trap message.
14. Set the upper threshold for
the PPPoE abnormal offline
event percentage.
pppoe-server
abnormal-offline-percent
threshold
number
Optional.
100 by default.
If the PPPoE abnormal offline
event percentage in the last 5
minutes exceeds this threshold,
the system outputs a trap
message.
15. Set the lower threshold for
the PPPoE normal offline
event percentage.
pppoe-server
normal-offline-percent
threshold
number
Optional.
0 by default.
If the PPPoE normal offline event
percentage in the last 5 minutes
is lower than this threshold, the
system outputs a trap message.
16. Configure authentication
and accounting on PPP
users.
See Security Configuration Guide.
Optional.
17. Disable PPP log displaying.
pppoe-server log-information
off
Optional.
Enabled by default.
When you configure a static route on a VT interface, specify the next hop instead of the outgoing
interface. If the outgoing interface is required, make sure the physical interface bound to the VT
interface is effective to ensure normal transport of packets.
Configuring a PPPoE client
PPPoE client configuration includes dialer interface configuration and PPPoE session configuration.
Configuring a dialer interface
Before establishing a PPPoE session, you must first create a dialer interface and configure a dialer
bundle on the interface. Each PPPoE session uniquely corresponds to a dialer bundle and each
dialer bundle uniquely corresponds to a dialer interface. A PPPoE session uniquely corresponds to a
dialer interface.

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English