HPE FlexNetwork MSR Series Comware 5 Layer 2 - Wan Access Configuration Guide

226
Step Command Remarks
3. Configure the maximum
number of information
frames the router can receive
before it must send an
acknowledgement.
llc2 max-ack
length 3 by default.
4. Configure the maximum
number of consecutive
information frames the router
can send before receiving an
acknowledgement from the
peer.
llc2 receive-window
length
Optional.
7 by default.
5. Configure the LLC2 output
queue length.
llc2 max-send-queue
length
Optional.
50 by default.
6. Configure the modulus value
of LLC2.
llc2 modulo
{
8
|
128
}
Optional.
128 by default.
7. Configure the number of
LLC2 transmission retries.
llc2 max-transmission
retries
Optional.
3 by default.
8. Configure the maximum
LLC2 PDU.
llc2 max-pdu
length
Optional.
1493 bytes by default.
9. Configure the LLC2 local
acknowledgment delay time.
llc2 timer ack-delay
mseconds
Optional.
100 ms by default.
10. Configure LLC2
acknowledgment waiting
time.
llc2 timer ack
mseconds
Optional.
200 ms by default.
11. Configure the LLC2
busy-station polling interval.
llc2 timer busy
mseconds
Optional.
300 ms by default.
12. Configure the LLC2 P/F
waiting time.
llc2 timer poll
mseconds
Optional.
5,000 ms by default.
13. Configure the LLC2 REJ
status time.
llc2 timer reject
mseconds
Optional.
500 ms by default.
14. Configure the LLC2 POLL
timer.
llc2 timer detect
mseconds
Optional.
30,000 ms by default.
Configuring the multicast function of DLSw v2.0
Before you configure the multicast function of DLSw v2.0, you must first configure the multicast
function of the device, and configure the local DLSw peer. After DLSw v2.0 multicast is enabled, the
origin DLSw v2.0 device can multicast SOCKET messages (with explorer frames encapsulated) to a
specific multicast address, so all target DLSw v2.0 routers listening to the multicast address can
receive the SOCKET messages and get the explorer frames.
When you configure the multicast function of DLSw v2.0, follow these guidelines:
• By default, the DLSw multicast function is disabled on devices running DLSw v2.0. To enable
this function, use the dlsw multicast command.
• Before enabling the DLSw multicast function, configure the outbound multicast interface
specified with interface interface-type interface-number in the above-mentioned command on
the same interface as the local DLSw peer.
• To enable the DLSw multicast function, execute the related multicast command first.

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English