HPE FlexNetwork MSR Series Comware 5 Layer 2 - Wan Access Configuration Guide

225
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Map a bridge set to DLSw.
dlsw bridge-set
bridge-set
By default, no bridge set is
mapped to DLSw.
This command should be used in
conjunction with the
bridge
bridge-set
enable
command, with
the same bridge-set value in both
commands.
Adding an Ethernet interface to a bridge set
By adding an Ethernet interface to a bridge set and mapping the bridge set to DLSw, you can enable
transmission of LLC2 frames from the Ethernet interface to a remote end over a TCP connection.
For more information about bridge set configuration, see "Configuring bridging."
Setting DLSw timers
Configure the timers used in creating DLSw circuits based on your actual needs. The timer values
should be modified only when necessary.
To set DLSw timers:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Configure DLSw timer
parameters.
dlsw timer
{
cache
|
connected
|
explorer
|
explorer-wait
|
local-pending
|
remote-pending
} seconds
The following defaults apply:
• cache—120 seconds.
• connected—300 seconds.
• explorer—30 seconds.
• explorer-wait—30 seconds.
• local-pending—30
seconds.
• remote-pending—30
seconds.
Configuring LLC2 parameters
SNA was designed to transmit LLC2 frames over Ethernet. Modify some LLC2 parameters by using
LLC2 related commands.
To configure LLC2 parameters:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
N/A

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English