HPE FlexNetwork MSR Series Comware 5 Layer 2 - Wan Access Configuration Guide

136
Task Remarks
Enabling RS-DCC
Required.
Configuring a dial string for the dialer interface
Required.
Assigning physical interfaces to the dialer bundle
Required.
Configuring dial authentication for RS-DCC
Required.
Enabling RS-DCC
Step Command
1. Enter system view.
system-view
2. Create a dialer interface and enter dialer
interface view.
interface dialer
number
3. Set the remote username.
dialer user
username
4. Enable RS-DCC by creating a dialer bundle for
the dialer interface.
dialer bundle
number
Configuring a dial string for the dialer interface
In the RS-DCC approach to on-demand dial, the attributes of physical interfaces vary by dial string.
Therefore, DCC parameters must be configured on dialer interfaces and dial strings can be
configured only with the dialer number command. For each dialer interface, you can configure only
one dial string.
To configure a dial string for the dialer interface:
Step Command
1. Enter system view.
system-view
2. Enter dialer interface view.
interface dialer
number
3. Configure a dial string for calling a remote end.
dialer number
dial-number
Assigning physical interfaces to the dialer bundle
A dialer bundle is a collection of physical interfaces with different priorities. When placing a call, DCC
selects a physical interface from the bundle in priority order.
To assign physical interfaces to the dialer bundle:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter physical interface
view.
interface
interface-type
interface-number
N/A

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English