90
c. Select radio unit 1.
d. Set the wireless service name as mac-auth.
e. Select the wireless service type clear.
f. Click Apply.
2. Configure MAC authentication:
After you create a wireless service, the wireless service configuration page appears. Then you
can configure MAC authentication on the Security Setup area.
Figure 76 Configuring security settings
a. Select Open-System from the Authentication Type list.
b. Select the Port Set option, and select mac-authentication from the Port Mode list.
c. Select the MAC Authentication option, and select system from the Domain list.
d. Click Apply.
3. Enable the wireless service:
a. Select Interface Setup > Wireless > Access Service from the navigation tree.
Figure 77 Enabling the wireless service
b. Select the mac-auth option.
c. Click Enable.
4. (Optional.) Enable 802.11g radio. By default, the 802.11g radio is enabled.
Select Interface Setup > Wireless > Radio from the navigation tree to enter the Radio page.
Make sure 802.11g is enabled.
To Next Page
Loading...
