264
Figure 653 Call routing binding page of number substitution list 21102
10. Select Apply Call Routing Binding Rule to Calling Numbers for Binding Mode.
11. Select call route 10.
12. Click Apply.
Configuring Router A
# Set the IP address of the Ethernet interface to 1.1.1.1.
# Add a call route: specify the call route ID as 1010, the destination number as …., and the trunk
route line as FXO line 1/0 on the call route configuration page. In addition, you need to select the
Send All Digits of a Called Number option in the Called Number Sending Mode area when you
configure the advanced settings of this call route; you also need to select the Enable option in the
Hunt Group area when you configure the call services of this call route.
# Add a call route: specify the call route ID as 2010, the destination number as ...., and to the trunk
route line as FXO line 1/1 on the call route configuration page. In addition, you need to select the
Send All Digits of a Called Number option in the Called Number Sending Mode area when you
configure the advanced settings of this call route; you also need to select the Enable option in the
Hunt Group area when you configure the call services of this call route.
# Add number substitution rule list 101 for called numbers of incoming calls.
Select Voice Management > Dial Plan > Number Substitution from the navigation tree, and click
Add to access the number substitution configuration page.
To Next Page
Loading...
Need help?
General
