6. Operation of ELECYLINDER
375
[Driving Easy Programming]
Touch the first (on the most left) step of the easy
programmng.
Input a position number or a timer (T1 to T5) and touch
[ENT].
Set the next step and after in the same manner.
Set R at the end when it is required to repeat the operation.
Touch a timer to use (T1 to T5) when it is required to have
time for pause.
Set the time for pause.
Have the servo ON and the home-return conducted, and
then touch [Start] button to start the operation.
To Next Page
Loading...