IAI TB-02 - Page 396

7. Gateway Parameter Setting Tool
384
GW Mode Select
[Setting Items]
 Enable valid (Vailt/Invalid)
 Byte swap (Vailt/Invalid)
 Double byte data word swap (Vailt/Invalid)
 Enable valid at AUTO (Vailt/Invalid)
 Pressing system in Direct Numerical Mode (CON
mode/SEP mode)
Unit Select
[Setting Items]
 Multidrop Permission (Accept/Not accept)
 Unit Number (0/1)
 Top Axis Number (0 to 15)
(2) Special Parameters for RCP6S
GW Parameter
[Setting Items]
 Condition latch after the servo is turned off when ERR_T
occurred (Vailt/Invalid)
 Servo-off when ERR_C occurred (Vailt/Invalid)
 Velocity unit (in Direct Numerical Mode only)
 Communication Retry Number Setting
 Fan always-on operation (Vailt/Invalid)
 Fan revolution monitoring (Vailt/Invalid)
 Absolute battery charge voltage monitoring (ON/OFF)
 Calendar feature (Vailt/Invalid)
 Enable valid (SV-OFF/Shutdown)
 MON Signal (Vailt/Invalid)
Pages are to be switched over with ▲ and ▼ buttons.
GW Mode Select
[Setting Items]
 Enable valid (Vailt/Invalid)
 Byte swap (Vailt/Invalid)
 Double byte data word swap (Vailt/Invalid)
 Enable valid at AUTO (Vailt/Invalid)