7. Gateway Parameter Setting Tool
385
(3) Special Parameters for RCON
Gateway parameter
[Setting Items]
Condition latch after the servo is turned off when ERR_T
occurred (Vailt/Invalid)
Servo-off when ERR_C occurred (Vailt/Invalid)
Velocity unit (in Direct Numerical Mode only)
Communication Retry Number Setting
MON signal (Vailt/Invalid)
Calendar function (Vailt/Invalid)
Number of power supply units connected (Not
used/1/2/3/4/5)
Power supply unit monitor type (Output voltage /
Auxiliary winding wire voltage / Output current / Peak
hold current / Load factor / Fan rotating speed / PCB
temperature)
Power supply unit connection retry times
Waiting time for init. internal process comm. [ms]
Pages are to be switched over with ▲ and ▼ buttons.
GW Mode Select
[Setting Items]
Enable valid (Vailt/Invalid)
Byte swap (Vailt/Invalid)
Double byte data word swap (Vailt/Invalid)
Driver shutdown release dalay time [ms]
Refer to the instruction manual for each control for detail of each setting item.
To Next Page
Loading...