Keysight Technologies C Series - Page 148

148 Keysight N9915-90020 User’s Guide
SA (Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)FUTURE
The graphic above shows an SA display with markers.
Carrier with 5 kHz frequency modulation and deviation of 1 kHz.
In this Chapter
“Frequency Range” on page 151
“Baseband (N99xxC-Series FieldFox Models Only with Option 350 RTSA or
Option 233 SA–Mixed Models)” on page 153
“Radio Standard” on page 155
“Channel Selection” on page 156
“Reverse Swap” on page 158
“Scale and Units” on page 159
“External Gain” on page 160
“Attenuation Control” on page 161
“Preamplifier Control (Opt 235)” on page 162
“Check for Compressed Measurements” on page 162
“Field Strength Measurements” on page 163
“Using the Antenna/Cable Editor” on page 165
“Source Tracking Offset and Offset Reversal” on page 169
“Tune & Listen (AM/FM)” on page 170
“Analog Demod” on page 174
“Independent Source/Tracking Generator ” on page 186
“Resolution Bandwidth (Res BW)” on page 187
“Video Bandwidth (Video BW)” on page 188
“AF RBW (Audio-Frequency Resolution BW)” on page 188
“Sweep Type” on page 189
“IF Output” on page 190
“Sweep Acquisition” on page 193
“Very Long Sweep Times” on page 195
“Zero Span Measurements” on page 195
“Triggering” on page 197
“FFT Gating (Opt 238)” on page 201
“Single / Continuous / Restart” on page 203