Keysight E4980A - Page 405

Keysight E4980A/AL Precision LCR Meter 405
SCPI Command Reference
Command list
MEAS
ABORT
Resets the trigger system, putting the trigger in the IDLE
STATE on the state diagram
MEASUR
E
Executes a single measurement and enters two measured
values into each of the reference values for the deviation
measurement
:FUNC:DEV1:REF:FILL
REF B Sets the reference value for deviation measurement :FUNC:DEV2:REF:VAL
MEAS
ABORT
Resets the trigger system, putting the trigger in the IDLE
STATE on the state diagram
MEASUR
E
Executes a single measurement and enters two measured
values into each of the reference values for the deviation
measurement
:FUNC:DEV2:REF:FILL
STEP DLY Sets the step delay time :TRIG:DEL
TRIG
BUS Selects the trigger mode :TRIG:SOUR BUS
EXT Selects the trigger mode :TRIG:SOUR EXT
INT Selects the trigger mode :TRIG:SOUR INT
MAN Selects the trigger mode :TRIG:SOUR HOLD
TRIG DLY Sets the trigger delay time :TRIG:TDEL
USER
COMMENT
2
ADD
CHAR
Inputs the comments
ENTER Enters arbitrary comments into the comment line :DISP:LINE
NEXT Displays the next page
PREV Displays the previous page
VDC MON
OFF Disables the DC voltage level monitor function :FUNC:SMON:VDC:STAT
OFF
ON Enables the DC voltage level monitor function :FUNC:SMON:VDC:STAT
ON
[Preset]
CLEAR
SET&CORR
Key Operation Function SCPI Command