111
Program operating mode
Page 5 - Pitch LFO2
The“LFO1Intensity”,“JS+Y”and“AMS”settingswill
be added to determine the depth and direction of the
pitchmodulationappliedbyLFO1.
‐12.00…+12.00
Parametervalue.
PAGE 5 - PITCH LFO2
InthispageyoucansettheLFO2modulationparame ‐
ters for the selected oscillator. See “Page 4‐
Pitch
LFO1”forinformationonthevariou
sparameters.
PAGE 6 - PITCH EG
Hereyoucan makesettingsforthepitchEG,whichcre‐
atestime‐variantchangesinthepitchoftheoscillators.
The depth of pitch change produced by these EG set‐
tings on
the oscillators is adjusted by the “Intensity
(AMS1/2Intensity)”parameter(s
eepage111).
Pitch envelope
Start/Attack/Decay/Release Level
Theseparametersspecify the amount of pitch change.
Theactualamountofpitchchangewilldependonthe
“Intensity (AMS1/2 Intensity)” parameter (s
ee below).
For example, with an “Intensity” setting of +12.00, a
“Level”settingof+99wouldraisethepitchoneoctave,
anda“Level”setti ngof–99wouldlowerthepitchone
octave.
‐99
…+99 Parametervalue.
Start Level
Specifiestheamountofpitchchangeatnote‐on.
Attack Level
Specifies the amount of pitch change when the attack
timehaselapsed.
Release Level
Specifiestheamountofpitchchange whentherelease
timehaselapsed.
Attack/Decay/Release Time
Theseparametersspecifythetimeoverwhichthepitch
changewilloccur.
0…99 Parametervalue.
Attack Time
Specifies the time over which the pitch will change
fromnote‐onuntilitreachesthe pitchspecifiedasthe
attacklevel.
Decay Time
Specifies the time over which the pitch will change
after reaching the attack level until it reaches the nor‐
malpitch.
Release Time
Specifies the time over which the pitch will change
fromnote‐offuntilitreachesthepitchspecifiedasthe
releaselevel.
Pitch EG ‘Level’ modulation
AMS1/2 (L) (Alternate Modulation Source 1/2)
Theseparam etersselectthesourcethatwillcontrolthe
pitchEG“Level”parameters(“A M S (AlternateModu‐
lationSource)list”onpage123).
Intensity (AMS1/2 Intensity)
These parameters specify the depth and direction of
the effect applied by “AMS1”. With a setting of 0, the
levelsspecified by “Start/Attack/Decay/Release Level”
willbeused.
Forexampleif“A M S 1 ” isJoystick+Y
,pushingthejoy‐
sticktoturnitonwillchangethe“Level”paramete
rsof
the Pitch EG. As the absolute value of “Intensity” is
increased,the pitchEGlevelswillchangemoregreatly
when the joystick is released. The direction of the
changeisspecifiedby“StartLev
elSwing”and“Att
ack
Level Swing”. When the key pressure is released, the
pitchEGlevelswi
llreturntotheirownsettings.
If“AMS1”issettoVelocity,increasingtheabsolutevalue
of“Intensity”willproduceincreasinglywiderchangein
pitchEG levelsforstrongly‐playednotes.The direction
of the change is specified by “Start Lev
el Swin g” and
“A t t a
c k LevelSwing”.Asyoupl
aymoresoftly,thepitch
changewilldrawclosertothepitchEGlevels.
‐99…+99 Parametervalue.
Note-on
Note-off
Attack
Time
Decay
Time
Start Level
Release Level
Release Time
Attack Level
+99 = approximately 1 octave
–99 = approximately 1 octave
0 = pitch when
key is held
(sustained)
Time
Time-varying pitch settings (when Pitch EG Intensity = +12.00)
Pitch EG change (level) (AMS=JS-Y/Velocity, Intensity= positive (+) value
Note-on
Note-off
Note-on
Note-off
Note-on
Note-off
A note played softly with
Start Level Swing set at 0,
Attack Level Swing set to +,
the Joystick pulled on
A note played strongly with
Start Level Swing set to 0,
Attack Level Swing set to +,
the Joystick pulled on
A note played strongly with
Start Level Swing set to 0,
Attack Level Swing set to –,
the Joystick pulled on
To Next Page
Loading...
Need help?
General
