199
038: PitchShift
(Pitch Shifter)
This effect changes the pitch of the input signal. You
can select from three typ
es: Fast (quick response),
Medium, and Slow (preserves tonal quality). You can
also create an effect in which the pitch is gradually
raised(ordropped)usingthedelaywithfeedback.
a: Mode
This parameter switches the pitch shifter operating mode.
With Slow, tonal quality will not be changed too much. With
Fast, the effect becomes a Pitch Shifter that has a quick
response, but may change the tone. Medium is in between
these two. If you do not need to set too much pitch shift
amount, set this parameter to Slow. If you wish to change the
pitch significantly, use Fast.
b: Pitch Shift [1/2tone], b: Src, b
: Amt, c: Fine [cent], c:
Amt
The amount of pitch shift will use the value of the “Pitch Shift”
plus the “Fine” value. The amount of modulation will use the
c: Amt value plus d: “Amt.”
Modulation Source is used both for “Pitch Shift” and “Fine.”
e: Feedback Position, f: Feedback
When “Feedback Position” is set to Pr
e, the pitch shif
ter out-
put is again input to the pitch shifter. Therefore, if you specify
a higher value for the Feedback parameter, the pitch will be
raised (or lowered) more and more each time feedback is
repeated.
If “Feedback Position” is set to Post, the
feedback signal will
not pa
ss through the pitch shifter again. Even if you specify a
higher value for the Feedback parameter, the pitch-shifted
sound will be repeated at the same pitch.
a
Mode Slow, Medium, Fast
Switches Pitch Shifter mode
b
Pitch Shift [1/2tone] –24...+24
Sets the pitch shift amount by steps of a semitone ,
Src Off...Tempo
Selects the modulation source of pitch shift amount
Amt
Sets the modulation amount of pitch shift amount
–24...+24
c
Fine [cent]
Sets the pitch shift amount by steps of a cent
–100...+100cent
,
Amt
Sets the modulation amount of pitch shift amount
–100...+100cent
d
Delay Time [msec]
Sets the delay time
0...1000msec
e
Feedback Position
Switches the feedback connection.
Pre, Post
f
Feedback
Sets the feedback amount
–100...+100
High Damp [%]
Sets the damping amount in the high range
0...100%
g
Input Level Dmod [%] –100...+100
Sets the modulation amount of the input level Fx:037,
Src
Selects the modulation source for the input level
Off...Tempo
Fx:037
h
Wet/Dry Dry, 1:99...99:1, Wet
Ta bl e , “Sets the balance between the effect and dry sounds,” on page 175
Src Off...Tempo
Ta bl e , “Selects the modulation source of the effect balance,” on page 175
Amt
Ta bl e , “Sets the modulation amount of the effect bal-
ance,” on page 175
–100...+100
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Input Level
Input Level
+
High Damp
Delay
Feedback
Pitch Shifter
Feedback Position
Pre
Post
To Next Page
Loading...
Need help?
General
