208
Reverb effects
Theseeffectssimulatetheambienceofreverberationin
concerthalls.
052: Rev. Hall
This hall‐type reverb simulates the reverberation of
mid‐sizeconcerthallsorensemblehalls.
053: RevSmthHall
(Smooth Hall)
This hall‐type reverb si
mulates the reverberation of
largerhallsandstadiums,andcreatesasmoothrelease.
054: RevWetPlate
This plate reverb simulat es warm (dense) reverbera‐
tion.
055: RevDryPlate
Thisplatereverbsimulatesdry(light)reverberation.
b: Pre Delay [msec], b: Pre Delay Thru [%]
The “Pre Delay” sets the delay time to the reverb input, allow-
ing you to control spaciousness.
Using the “Pre Delay Thru” parameter, you can mix the dry
sound without delay, e
mphasizing the attack of the sound.
056: Rev. Room
Thisroom‐typereverbemphasizestheearlyreflections
that make the sound tighter. Changing the balance
betweentheearlyreflectionsandreverbsoundallows
youtosimulatenuances,suchasthetypeofwallsofa
room.
057: R.BriteRoom
Thisroom‐typereverbemphasizestheearlyreflections
thatmakethesoundbrighter.See056:ReverbRoom.
c: ER Level, d: Reverb Level
These parameters set the early reflection level and reverb
level
.
Changing these parameter values allows you to simulate the
type of walls in the room. That is, a larger “ER Leve
l” simu-
lates a hard wall, and a larger “Reverb Level” simulates a soft
wall.
REVERB
a
Reverb Time [sec]
Sets the reverberation time
0.1...10.0sec
High Damp [%]
Sets the damping amount in the high range
0...100%
b
Pre Delay [msec]
Sets the delay time from the dry sound
0...200msec
Pre Delay Thru [%]
Sets the mix ratio of non-delay sound
0...100%
c
EQ Trim
Table , “Sets the EQ input level,” on page 176
0...100
d
Pre LEQ Gain [dB]
Table , “Sets the gain of Low EQ,” on page 176
–15...+15dB
Pre HEQ Gain [dB]
Table , “Sets the gain of High EQ,” on page 176
–15...+15dB
e
Wet/Dry Dry, 1:99...99:1, Wet
Table , “Sets the balance between the effect and dry sounds,” on page 175
Src Off...Tempo
Table , “Selects the modulation source of the effect balance,” on page 175
Amt
Table , “Sets the modulation amount of the effect bal-
ance,” on page 175
–100...+100
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
EQ Trim
+
EQ Trim
LEQ HEQ
Pre Delay
Reverb
Pre Delay Thru
Reverb - Hall / Plate Type
Time
Level
Louder
Dry
Reverb
Pre Delay Thru
Pre Delay
Reverb Time
a
Reverb Time [sec]
Sets the reverberation time
0.1...3.0sec
High Damp [%]
Sets the damping amount in the high range
0...100%
b
Pre Delay [msec]
Sets the delay time from the dry sound
0...200msec
Fx:052
Pre Delay Thru [%]
Sets the mix ratio of non-delay sound
0...100%
Fx:052
c
ER Level
Sets the level of early reflections
0...100
d
Reverb Level
Sets the reverberation level
0...100
e
EQ Trim
Table , “Sets the EQ input level,” on page 176
0...100
f
Pre LEQ Gain [dB]
Table , “Sets the gain of Low EQ,” on page 176
–15...+15dB
Pre HEQ Gain [dB]
Table , “Sets the gain of High EQ,” on page 176
–15...+15dB
g
Wet/Dry Dry, 1:99...99:1, Wet
Table , “Sets the balance between the effect and dry sounds,” on page 175
Src Off...Tempo
Table , “Selects the modulation source of the effect balance,” on page 175
Amt
Table , “Sets the modulation amount of the effect bal-
ance,” on page 175
–100...+100
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
EQ Trim
+
EQ Trim
LEQ HEQ
Pre Delay
Reverb
Reverb Level
ER Level
ER Level
Pre Delay Thru
ERs
ERs
Reverb - Room Type
Time
Level
Louder
ER
(Early Reflections)
Dry
Reverb
Pre Delay Thru
Pre Delay
Reverb Time
To Next Page
Loading...
Need help?
General
