Korg microARRANGER - Playing a Song from a Card

31
Tutorial
Playing a Song from a card
9 Finish the recording.
PRESS PLAY/STOP (SEQ1)
and the Recording status will be gone. Both Backing
Sequ
ence tracks (RT and Ch/Acc) will be set to the
PLAYstatus.
10 Listen to the Song.
When back in the Backing Sequence Play page, press
PLAY
/STOP (SEQ1) to listen to the new Song. How
smartwereyou?
If the Song is fine, you can switch to the Song  mode
and do some ed
iting. Or you can save it (as seen
below),andplayitinSong Playmode.
11 Deleting one of the tracks, or the whole Song
and re
cord again.
That’seasy! 
1. PressRECORDtoenterRecordmode
.
2. Set the track  to dele
te and set the REC statu
s to
record.
3. Setthetrackyouwanttolist
entoduringrecording
toPLAY status. If you don’twanttodelete it, but
youdon’twanttolistentoit,setthetracktoMUTE
status.
4. Startrecordingagain.Ifyou arerec
ordingthe RT
track,youcan’tusetheStylecontrols.
5. Press PLAY/STOP  (SEQ
1) to finish the Song and
exitRecordingmode.
12 Time to save your Song.
If you don’t save your Song, it will be los
t when you
turn the instrument off, or switch to the Song Play
mode. You must save toacardany Song you wish to
preserve.
1. InsertyourSDcardintothecardslot.
2.
IntheBackingSequencePlaypage,selecttheʺSave
Songʺ
parameter.
3. Pressthe[F‐1]buttontoselecttheSDcard(SD).
4. Movethefol
derwhereyouwishtosav
eyourSong
tothefirstlineof thedisplay,usingtheE–F(Scroll
Up) and G–H (Scroll Down) VOLUME/VALUE
buttons,ortheTEMPO/VALUEcontrols.PressF‐3
(OPEN) to open it. Close the current folder by
pressingF‐4(CLOSE).
5.
To create  a new file, move the “NEW_NAME.MID”
itemtothefirstlineofthedisplay
.
6. When the “NEW_NAME.MID”
 item is selected,
pressoneoftheAVOLUME/VALUEbuttons.You
arepromptedtoassignanametothenewfolder:
MovethecursorusingtheDOWN/‐andUP
/+but‐
tons. Select a character using the DIAL. Insert a
char
acter at the cursor position by pressing the
INSERT button. Delete a character at the cursor
positionbypressingtheDELETEbutton.
7. When you have finished wr
iting a name for the
new midifile,  press F‐2 (SAVE) to confirm. The
“A r e  you sure?” message will appear. Press
ENTERtoconfirm,orEXITtoabort.
Need more information?
Goto“BackingSequenceoperatingmode”onpage82.
The Reference Guide includes all the information you
need.
PLAYING A SONG FROM A CARD
1 Insert the card containing the Song into the
card slot.
2 Press the SONG PLAY button to access the
Song Play mode.