Korg microARRANGER User Manual

192
Effects
Pitch/Phase Mod.
028: AutoFadeMod. 
(Stereo Auto Fade Modulation)
Thisstereochorus/flangereffectenablesyoutocontrol
theLFOspeedandeffectbalanceusingaut
ofade,and
youcanspreadthesoundbyoffsettingthephaseofthe
leftandrightLFOsfromeachother.
029: 2Voice Res
This effect resonates the input signal at a specified
pitch.You cansetthepitch,outputlevel,and panset‐
tings for two resonators individually. Yo
u can control
theresonanceintensityviaanLFO.
a: Control Mode, e: Voice1: Resonance, h: Voice2:
Resonance
This parameter determines the resonance intensity.
When “Control
Mode” = Manual, the “Resonance” parame
ter
sets the intensity of resonance. If the “Resonance” parameter
has a negative value, harmonics will be changed, and reso-
nance will occur at a pitch one octave lower.
a
AUTOFADE Src Off...Tempo
Selects the modulation source that starts AutoFade
Fx:027,
Rate
Sets the rate of fade-in
1...100
Fx:027
Fade-In Dly (Fade-In Delay) [msec]
Sets the fade-in delay time
00...2000msec
Fx:027
b
LFO Waveform
Selects LFO Waveform
Triangle, Sine
LFO Shape –100...+100
Determines how much the LFO waveform is changed Fx:020
c
LFO Phase [degree] –180...+180
Sets the LFO phase difference between the left and right Fx:010
d
LFO Frequency Mod D-mod, AUTOFADE
Switches between D-mod and AUTOFADE for the LFO frequency modula-
tion Fx:027
e
LFO Frequency [Hz]
Sets the LFO speed
0.02...20.00Hz
Src
Selects the modulation source of LFO speed
Off...Tempo
Amt –20.00...+20.00Hz
Sets the modulation amount of LFO speed
f
L Delay Time [msec]
Sets the left channel delay time
0.0...500.0msec
R Delay Time [msec]
Sets the right channel delay time
0.0...500.0msec
g
Depth
Sets the depth of LFO modulation
0...200
h
Feedback
Sets the feedback amount
–100...+100
Fx:020
High Damp [%] 0...100%
Sets the feedback damping amount in the high range Fx:020
i
Wet/Dry Mod D-mod, AUTOFADE
Switches between D-mod and AUTOFADE for the effect balance modulation
Fx:027
j
Wet/Dry –Wet...–1:99, Dry, 1:99...Wet
Table , “Sets the balance between the effect and dry sounds,” on page 175
Fx:010, 020,
Src Off...Tempo
Table , “Selects the modulation source of the effect balance,” on page 175
Amt
Table , “Sets the modulation amount of the effect bal-
ance,” on page 175
–100...+100
AutoFade
LFO Frequency
Wet / Dry
Delay
Delay
Left
Right
Feedback
LFO Shape
LFO Phase
LFO: Tri / Sine
Wet / Dry
Wet / Dry
High Damp
Stereo In - Stereo Out
a
Control Mode Manual, LFO, D-mod
Switches the controls of resonance intensity ,
LFO/D-mod Invert Off, On
Reverses the Voice 1 and 2 control when LFO/D-mod is selected

b
LFO Frequency [Hz]
Sets the LFO speed
0.02...20.00Hz
D-mod Src Off...Tempo
Selects the modulation source that controls resonance intensity
c
Mod. Depth –100...+100
Sets the amount of resonance intensity control via LFO/D-mod
Trim
Sets the input level at the resonator
0...100
d
Voice1: Pitch
Sets the voice1 Pitch for resonance
C0...B8
Fine [cent] –50...+50
Fine-adjusts the voice 1 pitch for resonance
e
Voice1: Resonance –100...+100
Sets the intensity of resonance when Control Mode = Manual 
High Damp [%] 0...100%
Sets the damping amount of resonant sound in the high range 
f
Voice1: Level
Sets the Voice1 output level
0...100
Pan
Sets the Voice1 stereo image
L6...R6
g
Voice2: Pitch
Sets the Voice2 Pitch for resonance
C0...B8
Fine [cent]
Fine-adjusts the voice 2 pitch for resonance
–50...+50
h
Voice2: Resonance –100...+100
Sets the intensity of resonance when Control Mode = Manual 
High Damp [%] 0...100%
Sets the damping amount of resonant sound in the high range 
i
Voice2: Level
Sets the Voice2 output level
0...100
Pan
Sets the Voice2 stereo image
L6...R6
j
Wet/Dry Dry, 1:99...99:1, Wet
Table , “Sets the balance between the effect and dry sounds,” on page 175
Src Off...Tempo
Table , “Selects the modulation source of the effect balance,” on page 175
Amt
Table , “Sets the modulation amount of the effect bal-
ance,” on page 175
–100...+100
Left
Right
Resonance
Wet / Dry
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
High Damp
High Damp
Trim
Trim
+
Level
Level
Pan
Pan
Control Mode
D
-mod
LFO
Manual
Invert: On/Off
Resonator
Resonator
Pitch, Fine [cent]

Korg microARRANGER Specifications

General

Keyboard	61 keys (velocity sensitive)
Audio Outputs	2 x 1/4" (L/Mono, R)
MIDI	In, Out
USB	1 x Type B
Styles	304 preset styles
Sequencer	16-track MIDI sequencer
Song Playback	SMF (Standard MIDI File) format
Audio Inputs	1 x 1/4" (mic/line)
Speakers	2 x 10cm speakers
Display	Custom LCD
Power Supply	DC 12V
Amplification	Built-in amplifier