Lenze 8400 - Page 1578

Index
1578 Lenze · 8400 HighLine · Reference manual · DMS 12.0 EN · 06/2017 · TD23
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Angular trimming (C01070) 1050
Following error limit (C01071) 1050
Multiplier - angular trimming (C01072) 1050
Ramp settings (C01069) 1050
Setting (C01073) 1051
Synchronisation mode (C01075) 1051
Zero pulse divider (C01074) 1051
L_DigitalDelay 1366
L_DigitalDelay 2..3
Delay (C00721)
962
L_DigitalDelay_1 1366
Delay (C00720) 962
L_DigitalDelay_2 1368
L_DigitalDelay_3 1369
L_DigitalLogic 1370
L_DigitalLogic_1 1370
Function (C00820) 974
Truth table (C00821) 974
L_DigitalLogic_2 1372
Function (C00822) 975
Truth table (C00823) 975
L_DigitalLogic_3 1374
Function (C00828) 979
Truth table (C00829) 979
L_DigitalLogic5 1376
L_DigitalLogic5_1 1376
Function (C00824) 976
Truth table (C00825) 976
L_DigitalLogic5_2 1378
Function (C00826) 977
Truth table (C00827) 978
L_DT1 1380
L_DT1_1 1380
Gain (C00252) 867
Sensitivity (C00253) 867
Time constant (C00251) 866
L_FixSet_a 1381
L_FixSet_a_1 1381
Analog values (C00660) 947
L_FixSet_w 1382
L_FixSet_w_1 1382
Fixed values (C00661) 947
L_FixSet_w_2 1383
Fixed values (C00662) 947
L_GainOffset 1384
L_GainOffset_1 1384
L_GainOffset_2 1385
L_GainOffset_3 1386
L_GainOffsetP 1387
L_GainOffsetP 1-3
Parameter (C00677)
949
L_GainOffsetP_1 1387
L_GainOffsetP_2 1388
L_GainOffsetP_3 1389
L_GainOffsetPhiP 1390
L_GainOffsetPhiP 1-2
Parameter (C00678)
949
L_GainOffsetPhiP_1 1390
L_GainOffsetPhiP_2 1391
L_GearComp 1392
L_GearComp_1 1392
Num_Denom (C01048) 1043
Offset (C01047) 1043
L_Interpolator 1394
L_Interpolator_1 1394
Activation FB functions (C00950) 1025
Limit value - error cycles (C00952) 1026
No. of interpolation steps (C00951) 1025
Speed-up (C00953) 1026
L_JogCtrlEdgeDetect_1 (C00488) 910
L_JogCtrlExtension 1398
L_JogCtrlExtension_1 1398
L_Limit 1400
L_Limit 1-2
Min/Max (C00630)
942
L_Limit_1 1400
L_Limit_2 1401
L_LimitPhi 1402
L_LimitPhi 1-3
Min/Max (C00631)
942
L_LimitPhi_1 1402
L_LimitPhi_2 1403
L_LimitPhi_3 1404
L_MckCtrlInterface 518
L_MckCtrlInterface_1 518
Alternative function (C01297) 1088
L_MckStateInterface 525
L_MckStateInterface_1 525
Pos. selection (C01295) 1087
L_MFail 1405
Tn (C01470) 1096
Vp (C01469) 1096
L_MFail_1 1405
L_MPot 1416
L_MPot_1 1416
Acceleration time (C00802) 971
Deceleration time (C00803) 971
Inactive fct. (C00804) 971
Init fct. (C00805) 971
Lower limit (C00801) 970
Upper limit (C00800) 970
Use (C00806) 972
L_MulDiv 1420
L_MulDiv_1 1420
Parameter (C00699) 953
L_MulDiv_2 1421
Parameter (C00679) 949
L_Mux 1422
L_Mux_1 1422
L_Negation 1423