Lenze i950

Selecng parameters to be recorded
The oscilloscope supports up to eight channels, thus maximally eight parameters can be recor-
ded in an oscillogr
am. The Channels list eld serves to congure the parameters to be recor-
ded as signal sources:
Col-
umn
Name Meaning
1 - Curve colour for the representaon in the oscillogram
2 Ch Channel number
3 On on / o
4 Inv Inversion on / o
5 Name Selecon of the parameter to be recorded
6 yPos I Value at cursor I in vercal
direcon
7 yPos II Value at cursor II in vercal direcon
8 | ΔyPos | Dierence between the two values of yPos I and yPos II (displayed as amount)
9 Unit Scaling
10 AS Acvaon / deacvaon of the autoscaling funcon
11 1 / Div
12 Oset The oset value is subtracted from the recorded raw value before the scaling is execu-
ted. This serves to, e. g., make very small value uctuaons visible within one consis-
tently very high recording value (e. g. harmonics with a low amplitude).
13 Posion Regarding the vercal curve scale -5 ... 5, the posion value determines the vercal
posion of the zero point of the Y axis of a curve.
How to select a parameter for recording:
1.
Double-click the "Name" column in the Channel list eld to open the "Selecon of signal
sources" dialog box.
2.Select the parameters to be recorded in the dialog box.
3.Press the "Ok" buon. This closes the dialog box and the selecon is accepted.
4.Repeat the steps 1 ... 3 to select up to seven further parameters to be recorded.
The selected parameters are recorded when the oscilloscope is started.
How to change a parameter for recording:
1.Double-click the parameter to be changed in the Channels list eld in the "Name" column.
2.Make a new selecon in the "Selecon of signal sources" dialog box.
3.Press the "Ok" buon. This closes the dialog box and the selecon is accepted.
The changed parameters are recorded when the oscilloscope is started.
How to cancel a selecon again:
1.Right-click the parameter to be removed in the Channels list eld in the "Name" column to
open the context menu.
2.Select the "Remove parameter" command in the context menu.
The selected and changed parameter will not be recorded anymore when the oscilloscope is
started.
Dening the recording me / sample rate
Addional
funcons
Oscilloscope funcon
390