215676 197 Revision A
To configure the float presets:
1. Engage the header.
Figure 4.73: Float Preset Switch
2. Move FLOAT PRESET SWITCH (A) to position 1 (B).
Figure 4.74: Cab Display Module (CDM) Float Adjustment
A - CDM Display B - Left Float Adjustment C - Right Float Adjustment
D - Header Tilt Down E - Header Lower F - Header Tilt Up
3. Using HEADER DOWN switch (E), lower the header fully, so that the lift cylinders are fully retracted.
4. Set the left and right float fine adjustments on the CDM to approximately 5.0:
a. Using FLOAT SELECTOR switch (B), push + to increase the float or – to decrease the float on the left side of the
header. CDM display (A) will show the selected float setting for the left side (for example: 5.0 L FLOAT R XX.X).
b. Repeat the previous step for the right side of the header float using switch (C). The display will show the float
setting for both sides, (for example, 5.0 L FLOAT R 5.0).
OPERATION
To Next Page
Loading...
