MacDon M155 2022 - 5.11.6 Traction Drive Hydraulics

215676 408 Revision A
5.10.8 Replacing Bulbs in Red and Amber Lights
If a bulb in a red or amber light is damaged or burnt out, it will need to be replaced.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator’s seat for any reason.
1. Shut down the engine, and remove the key from the ignition.
1000891
A
A
Figure 5.163: Windrower Cab-Forward
2. Turn the lights OFF.
3. Holding onto handholds (A) on the cab’s front corners,
stand on the header anti-slip strips, or stand on the
maintenance platform.
1000890
A
Figure 5.164: Red and Amber Lights
4. Remove two screws (A) from the lens. Remove the lens.
5. Push and twist the light bulb to remove it from its socket.
6. Install the new bulb in its socket, ensuring that the base of
the bulb is properly engaged in its socket.
• Replace the bulb in a red light with trade #1157.
• Replace the bulb in an amber light with trade #1156.
7. Reinstall the lens and secure it with screws (A).
5.10.9 Replacing Red Taillights
If a red taillight is damaged, it will need to be replaced.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator’s seat for any reason.
Red taillights are included with the lighting and marking for cab-forward road travel kit (MD #B5412).
MAINTENANCE AND SERVICING