215676 62 Revision A
3.16 Engine Controls and Gauges
The ignition, fuel gauge, engine temperature gauge, and throttle are located on the operator’s console.
Figure 3.43: Engine Controls and Gauges
Ignition switch (A)
The features of the windrower which are active depend on the
position of the ignition key:
• ACC (accessory): Features such as exterior lighting will be
available in this mode. Turn the ignition key fully
counterclockwise to activate this mode
• OFF: One position clockwise of ACC. The engine and all
accessories will be off when the key is in this position.
• RUN: The key will remain in this position after the engine
has been started.
• START: Turn the ignition key fully clockwise to crank the
engine. Once the engine has started, the key will sit in
the RUN position
NOTE:
Remove the key when the windrower is not in use; the key also locks the windrower’s cab doors.
Engine coolant temperature gauge (B)
• Normal running temperature: 82°–104°C (180°–220°F)
NOTE:
For information about temperature warnings and alarms, refer to Display Warnings and Alarms, page 82.
Fuel gauge (C)
• E: Empty
• F: Full
Throttle (D) controls engine speed
• FULL: Push the throttle lever fully forward to run the engine at its maximum speed
• OPERATING: Refer to Driving Forward in Cab-Forward Mode, page 168 to learn the appropriate engine speed for
various tasks.
• CLOSED: Pull the throttle lever all the way back
OPERATOR’S STATION
To Next Page
Loading...
