215676 372 Revision A
Figure 5.96: Coolant Recovery Tank
22. Replace cap (A) on coolant recovery tank (B).
23. Close the platform. For instructions, refer to 5.4.2 Closing
Platforms – Standard Position, page 320.
24. Close the hood. For instructions, refer to 5.3.4 Closing Hood
– Highest Position, page 318.
Adding Coolant
Check the coolant level in the coolant recovery tank daily. Add coolant if the tank is less than one-half full.
NOTE:
For coolant specifications, refer to the inside back cover.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator’s seat for any reason.
CAUTION
To avoid personal injury from hot coolant, do NOT attempt to open the radiator cap until the engine cools.
NOTE:
Do NOT add coolant directly into the radiator except when changing coolant.
1. Shut down the engine, and remove the key from the ignition.
2. Open the hood to the highest position. For instructions, refer to 5.3.3 Opening Hood – Highest Position, page 317.
3. Move the platform on the left cab-forward side of the machine to the open position. For instructions, refer to 5.4.1
Opening Platforms – Standard Position, page 319.
MAINTENANCE AND SERVICING
To Next Page
Loading...
