215676 384 Revision A
9. Close the hood. For instructions, refer to 5.3.2 Closing Hood
– Lower Position, page 317.
5.9.10 Engine Speed
The engine ’ s idle and maximum speeds are factory set.
Refer to 2.2 Specifications, page 29 for detailed information. If specified speeds cannot be maintained, see your MacDon
Dealer.
IMPORTANT:
Do NOT remove any seals from the injector pump. Removal of seals will void the engine’s warranty.
To configure the engine’s intermediate speed control function, refer to Engine Intermediate Speed Control, page 162 .
Throttle Adjustment
The engine speed is controlled by a throttle lever connected to an electronic sensor inside the console.
The throttle lever in the cab should be able to move the throttle sensor through its full range without contacting the
console at any point.
If the throttle lever is contacting the console and interferes with the specified engine speeds, the sensor position may need
adjustment. Contact your MacDon Dealer for more information.
MAINTENANCE AND SERVICING
To Next Page
Loading...
