215676 288 Revision A
4.6 Operating with D or D1 Series Draper Header
Refer to this section to learn how to configure the hydraulics, change the reel settings, operate the draper and knives, and
use the optional deck shift controls on a D or D1 Series Draper Header.
Figure 4.289: Draper Header Hydraulics
The M155 Self-Propelled Windrower is factory-equipped to run
a D or D1 Series Draper Header.
If installing a HC10 Hay Conditioner, installing reverser kit
MD #B4656 is recommended. If necessary, obtain the
recommended kit from your MacDon Dealer and install it
according to the instructions supplied with the kit.
The procedure for attaching a D Series or D1 Series Draper
Header varies depending on the type of center-link installed on
the windrower. Refer to the relevant procedure:
• Attaching D or D1 Series Draper Header – Hydraulic Center-
Link with Self-Alignment, page 216
• Attaching D or D1 Series Draper Header – Hydraulic Center-
Link without Self-Alignment, page 221
• Attaching D or D1 Series Draper Header – Mechanical
Center-Link, page 227
4.6.1 Configuring Hydraulics
The windrower must be fitted with a basic draper drive hydraulic kit to operate a D or D1 Series Draper Header.
Figure 4.290: Draper Header Drive Hydraulics
Windrowers equipped with D or D1 Series hydraulics have four
header drive hoses on the left cab-forward side.
OPERATION
To Next Page
Loading...
