215676 12 Revision A
1.10 Safety Signs
Safety signs are decals placed on the machine where there is a risk of personal injury, or where the Operator should take
extra precautions before operating the controls. They are usually yellow.
Figure 1.19: Operator’s Manual Decal
• Keep safety signs clean and legible at all times.
• Replace safety signs that are missing or illegible.
• If the original part on which a safety sign was installed is
replaced, ensure that the repair part displays the current
safety sign.
• Replacement safety signs are available from your
MacDon Dealer Parts Department.
1.10.1 Installing Safety Decals
Replace any safety decals that are worn or damaged.
1. Decide exactly where you are going to place the decal.
2. Clean and dry the installation area.
3. Remove the smaller portion of the split backing paper.
4. Place the decal in position and slowly peel back the remaining paper, smoothing the decal as it is applied.
5. Prick small air pockets with a pin and smooth them out.
SAFETY
To Next Page
Loading...
