MacDon M155 2022 - Mechanical Center-Link; Pressure Sensor Kit; R;R1 Disc Drive Kit; R80 and R85 Rotary Header Drive Hydraulics - 4.0 M (13 Ft.)

215676 462 Revision A
7.3.6 Mechanical Center-Link
The mechanical center-link provides a manually adjustable connection between the windrower and the header/mower
conditioner.
MD #B4665
7.3.7 Pressure Sensor Kit
This kit provides enhanced monitoring of the knife drive (or reel drive) hydraulic pressure, and warns of overload
conditions.
MD #B5574
Instruction MD #169031 is included in the bundle.
7.3.8 R/R1 Disc Drive Kit
This kit includes a valve required to run an R/R1 Series Rotary Disc Header on an M155 SP Windrower.
MD #B4657
7.3.9 R80 and R85 Rotary Header Drive Hydraulics – 4.0 m (13 ft.)
This kit is required to allow operation of a 4.0 m (13 ft.) R80 or R85 Rotary Disc Header. The kit includes the header drive
plumbing and installation instructions.
MD #B5510
The installation instructions are included in the bundle.
7.3.10 Self-Aligning Center-Link
This kit allows the Operator to remotely position the center-link cylinder without leaving the operator’s station.
Hydraulic center-link (MD #B4650) must be installed.
MD #B4802
Instruction MD #169004 included in the bundle.
7.3.11 Spring with External Booster Spring
This kit increases the float capacity of the windrower. Install this kit on windrowers paired with headers which weigh more
than 2724 kg (6000 lb.).
The Spring with External Booster Spring kit (MD #B4659) includes two springs (one for each side) and mounting brackets.
Instruction MD #169032 is included in the bundle.
Table 7.1 Available Float Spring Kits for Different Header Types and Configurations
Header Type
Description
Header Configuration
Additional
Float Spring Kits
D130XL
9.1 m (30 ft.)
single reel,
double knife, timed
Transport
—
D130XL
9.1 m (30 ft.)
single reel,
double knife, timed
Transport
Upper Cross Auger
Vertical Knives
MD #B6047
OPTIONS AND ATTACHMENTS