215676 232 Revision A
Figure 4.148: Ground Speed Lever (GSL)
1. Start the engine.
2. Press HEADER UP switch (A) to raise the header to its
maximum height.
3. Rephase the cylinders if one end of the header does not
rise fully:
a. Press and hold HEADER UP switch (A) until both
cylinders stop moving.
b. Continue to hold the switch for 3–4 seconds. The
cylinders are now phased.
4. Shut down the engine, and remove the key from
the ignition.
Figure 4.149: Safety Prop
5. To engage the safety props on the lift cylinders:
a. Pull lever (A) and rotate it toward the header to lower
safety prop (B) onto the cylinder.
b. Repeat the previous step for the opposite lift cylinder.
OPERATION
To Next Page
Loading...
