215676 256 Revision A
Figure 4.210: Ground Speed Lever
1. Start the engine.
2. Press HEADER UP switch (A) on the ground speed lever
(GSL) to raise the header to its maximum height.
3. Rephase the cylinders if one end of the header does not
rise fully:
a. Press and hold HEADER UP switch (A) until both
cylinders stop moving.
b. Continue to hold the switch for 3–4 seconds. The
cylinders are now phased.
4. Shut down the engine, and remove the key from
the ignition.
DANGER
To prevent bodily injury from the fall of a raised header, always engage the safety props when working on or around a
raised header, and before going under the header for any reason.
Figure 4.211: Safety Prop
5. To engage the safety props on the lift cylinders:
a. Pull lever (A) and rotate it toward the header to lower
safety prop (B) onto the cylinder.
b. Repeat the previous step for the opposite lift cylinder.
OPERATION
To Next Page
Loading...
