215676 260 Revision A
Figure 4.220: Ground Speed Lever
1. Start engine and press HEADER UP switch (A) on ground
speed lever (GSL) to raise header to maximum height.
2. If one end of the header does NOT rise fully, follow these
steps to rephase the cylinders:
a. Press and hold the HEADER UP (A) switch until both
cylinders stop moving.
b. Continue to hold the switch for 3–4 seconds. The
cylinders are now phased.
3. Shut down the engine, and remove the key from
the ignition.
DANGER
To prevent bodily injury from the fall of a raised header, always engage the safety props when working on or around a
raised header, and before going under the header for any reason.
Figure 4.221: Safety Prop
4. To engage the safety props on the lift cylinders:
a. Pull lever (A) and rotate it toward the header to lower
safety prop (B) onto the cylinder.
b. Repeat the previous step for the opposite lift cylinder.
OPERATION
To Next Page
Loading...
