MacDon M155 2022 - 5.9.8 Inspecting Exhaust System; 5.9.9 Belts

215676 361 Revision A
1022753
A
B
C
D
Figure 5.76: Primary Fuel Filter
4. Install spring (A), cover (B), and collar (C). Hand tighten the
collar.
5. Add clean fuel to the filter until the fuel is level with the
top of filter element (D).
1022754
A
B
Figure 5.77: Primary Fuel Filter
6. Install vent cap (A). Hand tighten the vent cap.
7. Reconnect the water in fuel (WIF) sensor (not shown).
8. Start the engine. Allow the engine to idle for 1 minute.
9. While the engine is running, slowly open vent cap (A) and
allow the fuel level to drop to about 25 mm (1 in.) above
collar (B).
10. Close vent cap (A) and hand tighten the vent cap.
NOTE:
It is normal for the fuel level to fluctuate briefly after the
engine is started, and while it is operating.
1026645
A
Figure 5.78: Fuel Shut-off valve
11. Open valve (A) under the fuel tank.
MAINTENANCE AND SERVICING