Mitsubishi Electric MELSEC iQ-R Series - Page 1061

7 APPLICATION INSTRUCTIONS
7.27 Module Access Instructions
1059
7
■Applicable devices
*1 Only the DTOD(P) instruction can be used.
Processing details
• For (U/H), specify the start I/O number of a module or CPU module with upper 3 digits when it is represented by 4
hexadecimal digits.
To read the module name of a CPU module, specify the read start I/O number as in the following table.
Operand Bit Word Double word Indirect
specification
Constant Others
(U)
X, Y, M, L,
SM, F, B, SB,
FX, FY
J\ T, ST, C, D, W,
SD, SW, FD, R,
ZR, RD
U\G, J\,
U3E\(H)G
Z LT, LST,
LC
LZ K, H E $
(U/H)         
(s1)         
(s2)   
*1
   
(n)         
(1) Specify K4 or H4 as the start I/O number of the write-target module.
CPU module Read start I/O number
CPU No. 1 3E0H
CPU No. 2 3E1H
CPU No. 3 3E2H
CPU No. 4 3E3H
RX10 RX10RX10
RJ71EN71
RX10CPU RX10
0000H 0010H 0020H 0030H 0040H 0060H
PW
(1)