Mitsubishi Electric MELSEC iQ-R Series - Page 1720

1718
20 SERIAL COMMUNICATION INSTRUCTIONS
20.14 Reading User Frames
■Applicable devices
*1 Index modification is not available.
*2 FX and FY cannot be used.
*3 RD cannot be used.
*4 FD cannot be used.
*5 T, ST, C, and FD cannot be used.
■Control data
Operand Bit Word Double word Indirect
specification
Constant Others
(U)
X, Y, M, L,
SM, F, B, SB,
FX, FY
J\ T, ST, C, D, W,
SD, SW, FD, R,
ZR, RD
U\G, J\,
U3E\(H)G
Z LT, LST,
LC
LZ K, H E $
(U)
*1

*3
     
(s1) 
*4
     
(s2) 
*4
     
(d) 
*2

*5
     
Operand: (s1)
Device Item Description Setting range Set by
+0 Dummy  0 
+1 Result of reading Used to store the result of sending with the G(P).GETE instruction.
•0: Normal
• Other than 0: Error (error code)
 System
+2 Specified frame number Specifies the user-registered number. 1000 to 1199 User
+3 Allowable number of
bytes
Specifies the number of bytes storable in (s2), of the registered data of the read user
frame.
1 to 80 User
Number of registered
bytes
Used to store the number of bytes of the registered data of the read user frame.
• 1 to 80: Number of bytes of registered data
 System