Mitsubishi Electric MELSEC iQ-R Series - Page 1749

21 A/D CONVERSION INSTRUCTIONS
21.3 Restoring the User Range Setting Values
1747
21
■Control data
• For R60AD4, R60ADH4
Operand: (s)
Device Item Description Setting range Set by
+0 System area 
+1 Completion status The instruction completion status is stored.
• 0: Completed successfully
• Other than 0: Completed with an error (error code)
 System
+2 Save data type setting Used to store the set value that was set for Save data type
setting (s)+2 in the G(P).OGLOAD instruction.
• 0: Voltage specification
• 1: Current specification
0000H to 000FH System
+3 System area 
+4 CH1 Factory default setting offset value (L) System
+5 CH1 Factory default setting offset value (H) System
+6 CH1 Factory default setting gain value (L) System
+7 CH1 Factory default setting gain value (H) System
+8 CH2 Factory default setting offset value (L) System
+9 CH2 Factory default setting offset value (H) System
+10 CH2 Factory default setting gain value (L) System
+11 CH2 Factory default setting gain value (H) System
+12 CH3 Factory default setting offset value (L) System
+13 CH3 Factory default setting offset value (H) System
+14 CH3 Factory default setting gain value (L) System
+15 CH3 Factory default setting gain value (H) System
+16 CH4 Factory default setting offset value (L) System
+17 CH4 Factory default setting offset value (H) System
+18 CH4 Factory default setting gain value (L) System
+19 CH4 Factory default setting gain value (H) System
+20 CH1 User range setting offset value (L) System
+21 CH1 User range setting offset value (H) System
+22 CH1 User range setting gain value (L) System
+23 CH1 User range setting gain value (H) System
+24 CH2 User range setting offset value (L) System
+25 CH2 User range setting offset value (H) System
+26 CH2 User range setting gain value (L) System
+27 CH2 User range setting gain value (H) System
+28 CH3 User range setting offset value (L) System
+29 CH3 User range setting offset value (H) System
+30 CH3 User range setting gain value (L) System
+31 CH3 User range setting gain value (H) System
+32 CH4 User range setting offset value (L) System
+33 CH4 User range setting offset value (H) S
ystem
+34 CH4 User range setting gain value (L) System
+35 CH4 User range setting gain value (H) System
b15 b3 b2 b1 b0
0
…
CH4 CH3 CH2 CH1